15 59 24 Installing valve tappets of cylinder bank 1- 3 · 1. Check guide for damage. Refer to: Checking 6. Check dowel

15 59 24 Installing valve tappets of cylinder bank 1- 3 1. Check guide for damage. Refer to: Checking 6. Check dowel sleeves (4 ea.) of the bearing guide for valve tappet, Servo No. 15 59 02. saddles to ensure that they are properly seated in the cylinder head. Oil bearing 2. Fit guide. Tighten pan-headscrews (M6 x 35) surface. Fit bearing saddles in the correct from the inside to the outside. Tightening position and tighten evenly. Tightening torque: 10 Nm (7.5 ftlb.) torque: 10 Nm (7.5 ftJb.) 3. Lightly oil the valve tappet and fit it in the guide. 4. Lay the complete unit, camshafts with chain and tensioning element, in the cylinder head. The groove or tab of the camshaft position sensor cover must face outward in installed position. If the allocation should be uncertain, e.g. chain jumped over, reallocationis necessary. Refer to: Completing camshafts, ServoNo. 15 05 33. 401_1_98 E = Bearing saddle for inlet camshaft A = Bearing saddle for exhaust camshaft I~~ hf ,\ 7. Fit tensioning element(VarioCam).Tighten 3 ~=- M6 x 95 pan-headscrews. Tighteningtorque 10 Nm (7.5 ftlb.) 8. Unscrewtensioningscrew, special tool 9632, from the tensioning element. @ -- 246.-97 5. Fastenspecialtool, holding-downdevice 9611, with auxiliaryscrewsM6 x 45. 15 59 24 Installing valve tappets of cylinder bank 1- 3 15 -101 Printed in Germany -10, 1998 99615101