Engine -Cylinder head, valve drive 911 Carrera (996) · Install sealing ring

Engine -Cylinder head, valve drive 911 Carrera (996) Install sealing ring for intermediate shaft ~1. Check crankshaft housing bore for sharp edges. If there are sharp edges in the ~f crankcase bore (intermediate shaft receiver), chamfer (deburr)the edges with fine emery paper. , 2. Lightly grease new sealing ring and lay in the ",,' groove of the intermediate flange. Note The sealing ring must not be twisted and must not be pulled over sharp edges of the flange. 15230001 Note3. Position intermediate shaft flange on the bore and affix with new micro-encapsulated It must be possible to insert the intermediate hexagon-headbolts. shaft flange almost completelyinto the intermediate shaft bore by hand. Note 5. Tighten three micro-encapsulatedDo not exert any pressure on the threaded pin hexagon-headbolts (M6 x 20) evenlywhen pushing in the intermediate shaft flange, (tighteningtorque 10 Nm [7.5 ftlb.])as the threaded pin might otherwise be pressed inward into the intermediate shaft. As soon as the threaded pin projects at the intermediate shaft flange, screw the new locknut into position. 4. Position and align retaining device special tool 9642. Centre intermediate shaft and intermediate shaft flange by turning the crankshaftto and fro a little (max. 2° to 3°, lV~J - remove dowel pin from the belt pulleyfirst). ~ 15230003 15 -132 152319 Removing and installing sealing ring for intermediate shaft 99615129 Printed in Germany -38, 1999