Removing housing for coolant guide -GT3 · No. Procedure Instructions

Removing housing for coolant guide -GT3 No. Procedure Instructions Draincoolant. Open lid on the expansion tank. Undo the drain plugs on the two necks for coolant and collect the coolant. After draining the coolant, fit new sealing rings on the drain plugs. Tightening torque 10 Nm (7.5 ftlb.) to 15 Nm (11 ftlb.). (Figure shows only one of the two necks) 19550005 2 Removethe air cleaner assembly. Removethe complete air cleaner assembly. To do this, unscrewthe M6 x 34 fastening screws. Pull off cable from hot film mass air flow sensor and set aside. Undo the hose clamp on the throttle body. Take out air cleaner assembly. Then undo the rear hose clamp of the connectinghose on the throttle body and remove the connecting hose. 3 Loosen belt pulley on the hydraulic pump. Undo the three fastening screws on the belt pulley of the hydraulic pump, do not unscrew. 19550007