Removing housing for coolant guide -GT3 · No. Procedure Instructions

911 Carrera (996) Engine -Cooling Removing housing for coolant guide -GT3 No. Procedure Instructions 7 Removegenerator. With the battery disconnected, screw off the B+ wire of the alternating current generator. Unscrew the rear left fastening screw. Unscrew the front left fastening screw by approx. 1 cm and drive in again by tapping with a hammer (pressing out the rear threaded bushing). Unscrew the front left fastening screw and lift out the generator. 8 Removehydraulic pump. /""""""' "",, / """ / Undo the three fastening screws on the belt pulleyand remove the belt pulley. Unscrewthe two fastening screws on the expansiontank and the four fastening screws on the hydraulicpump. Pull the hydraulic pump and connected lines up out of the fastening bracket and set down on the \ right-handside. ~ \~:::_--~~:~~~19550012 9 Removeair-conditioningcompressor. Removethe compressor from the bracket. Unscrewthe three fastening screws for this purpose. For better accessibilityto the fastening screws, the throttle body can be swung upwards after releasing the left and right clamps on the intake distributor. .,.