Front wheel suspension, drive shafts 911 Carrera (996) · -Slide the protective tube/additional spring

Front wheel suspension, drive shafts 911 Carrera (996) Assembly -Slide the protective tube/additional spring assemblyon the piston rod. Slide the cup washer No.7 and stop plate No.4 as far as they will go into the correct position on the piston rod. 679_1_96 Use a socket wrench insert open on one side to tighten the fastening nut on the spring strut mount. In this way the specified tightening torque can be adhered to exactly. It is also possible to counter at the piston rod with special tool 9630 at the same time. Never use an 675_1_96 impact bolter to tighten the fastening nut. Push the pretensioned coil spring onto the vibration damper so that the end of the coil spring rests against the stop of the spring plate. Place spring strut mount (assembly of mounVback-upring/spring plate) onto the piston rod so that the end of the coil spring is located in the spring plate. Place stop plate in the correct position on the spring strut mount and screw a new fastening nut onto the piston rod. Make sure that the rubber part of the mount is properly seated in the recess in the spring strut mount (arrows). 2047_40 40 -12 40 Disassembling and assembling front spring strut 996407 Printed in Germany -21, 1999