42 09 19 Removing and installing rear tie rod (toe control arm) · Removal 4. Mark

911 Carrera (996) Rear wheel suspension, drive shafts 42 09 19 Removing and installing rear tie rod (toe control arm) Removal 4. Mark the position of the toe eccentric for 1. Raise vehicle and remove wheel. re-installation.Removethe toe eccentric and pull out the tie rod. 2. Undo the stabilizer on the bearing block and Installation the stabilizer mount. This is necessaryfor removal of the toe eccentric. 1. Install in reverse order. Before installing, give Counter with an open-endedwrench when all parts a visual check. removing from the stabilizer mount. Note 3. Press off ball joint on the wheel carrier using Whenreplacing tie rods, pay close attention to a commercially availableball joint extractor the correct allocation. (tie rod extractor) -refer to Workshop Install only identical tie rods -version A or EquipmentManual,chapter 2.4, No. 113. B -on a vehicle. When loosening the locknut, hold it with For a detailed explanation-distinguishing special tool 9546 (Torx screwdriver). characteristicsand Part No. -refer to "Tie rod replacemenf'(after installation). Note Do not damage the boot of the ball joint when pressing off the ball joint. If necessaryI coat the boot and the ball joint extractor with tyre mounting paste. ""a 292_99 2. Replacefastening nuts. ~..) ~ Use correct tightening torques. 42090001 3. Perform a suspension alignmentafter installation. 42 09 19 Removing and installing rear tie rod (toe control arm) 42 -21 Printed in Germany -31, 1999 9964221 ~