Rear wheel suspension, drive shafts 911 Carrera (996) · Installing left drive shaft

Rear wheel suspension, drive shafts 911 Carrera (996) Installing left drive shaft Install in reverse order Grease the toothing of the drive shaft with OptimolyHT. Carry out a visual inspection of all parts. Replaceself-lockingnuts. Use correct tightening torques. .~~~~--: Note When installing the spring strut and tightening the two control arms, make sure that the A -Single-part fastening nut 42210006 spring-strutfastening screw (on the wheel carrier) and the control arm fastening screws B -Two-part fastening nut (moveable washer/arrow)are only tightened in vehicle position. Part No. 999 084 640 02 (status 04/00) Vehicle position means: Vehicle standing on the wheels, or the wheel suspension is being raised with a universallift. Check wheel-alignmentvalues. This step is necessary due to removal of the A calibration of the sensor of the headlight upper control arms on the wheel carrier. beam adjustmentis not necessary. Note Onlyoptimised axle nuts -version B -for drive-shaftfastening are availablefrom the Parts Service. These two-part fastening nuts (M22) have a moveablewasher (arrows). Retrofitting is possible for all 911 Carrera (996) vehicles and for all Boxsters. 42 -42 42 21 19 Removing and installing drive shaft (Tiptronic transmission) 9964231 Printed in Germany. 39, 2000