Wheels, tires, suspension alignment 911 Carrera (996) · Wheel alignment Adjus

Wheels, tires, suspension alignment 911 Carrera (996) Wheel alignment Adjusting camber I After looseningthe lock nut, turn fccentric B Notes appropriately. Onlycheck or adjust wheel-alignmentvalues when prescribed preconditions are met (Page 44 -12). , ,-;=1 ~ .,i..." If the vehicle is measured front and rear I check and adjust the rear axle first. Nominal values are given on Page 44 -4 / --- 44 -5. After adjustment,tighten the appropriate ~ screwed connections with the prescribed tightening torque. See tables in Rep. Gr. 40 ~ and 42. -- The steering angle sensor must be calibrated if the previous wheel alignment 4-2_97 values (on rear and/or front axle) for vehicles with PSM were changed! See Note I description in 911 Carrera 4, Use special tool 9626 in combiryationwith a Servo No. 45 60 (Rep. Gr. 45). torque wrench to loosen and tight~n the Important! fastening nuts of the toe and cam~er & I Malfunctions in the PSM control eccentrics. The prescribed lock-n4ttightening .range if the steering angle torque of 100 Nm (74 ftlb.) a's9 corresponds sensor is not calibrated or is to a setting on the torque wrench lof approx. calibrated incorrectly. 100 Nm (74 ftlb.). > Calibrate the steering angle sensor with the wheels in straight-aheadposition. ~ Rear axle ~~'\I Prepare vehicle for checking and/or adjustment of wheel alignmentvalues. Place front wheels on ~ rotary table and rear wheels on rotary / sliding plates. Compressvehicle at front and rear by approximately25 mm 2-3 times and allow it to \ spring back freely. r Adjusting toe 6_97 After looseningthe lock nut, turn eccentric A appropriately. 44 -14 44 Suspension alignment, complete 996449 Printed in Gennany -39, 2000 ~