Wheels, tires, suspension alignment 9111 Carrera (996) · Driving onto measuring platform

Wheels, tires, suspension alignment 9111 Carrera (996) Driving onto measuring platform Due to the reduced vehicle height, additional access ramps, for example 959 access aids: are reqIJiredto drive the vehicle onto the measuringplatform. Otherwisethe front spoiler would bottom on the platform. A measuring platform without a sloped position is unsuitable. C7 Special tool 9647 72_99 Deviating points for 911 GT3 Id Onlythose points which deviate trfm the 911 Carrera (996) are listed. / Changed adjustmentvalues, For the measured-valuePicku! sr electronic wheel alignment testers requi e spoiler 71_99 adapters of 50 and 100 mm n length, depending on the wheel aljgnment Tools tester. This is the only mean of enabling The special tools for suspension alignmentof data transfer from the right si e to the left. the 91.1 Carrera (996) are also used for the The wheel alignmenttesters r commended 911 GT3. by Porsche which have a spo ler measuring program require 100 mm Additionally, a hook wrench insert (special tool spoiler adapters on the rear a Ie. Observe 9647) is required for the 911 GT3. The special the operating instructions fro manufacturer tool 9647 is required to change the vehicle of the measuring instrumenti necessary. height and to adjust the stabilizer mating bearing on the front and rear axle. The vehicle height of the 911 ~GT3 can be The special tool is used together with a torque adjusted at the front and rear axle by means wrench to tighten the lock nuts (slotted nuts) of the adjusting nut(s)on the orresponding .on the spring struts. Tightening torques in spring strut or struts. I Repair Group 40/42. Maximumwheel-loaddifferencle from left Important: The stabilizer mating bearing to right on front and rear axle 15 kg. must not be adjusted for street use. 44 -1Gb 44 Suspension alignment -GT3 9964416a Printed in Germany -25, 1999