Vehicle height 911 GT3 · General Note

Vehicle height 911 GT3 General Note The vehicle height on the front and rear axle of The heightadjustmentpossibilityallows: the 911 GT3 can be adjusted. 1. Differingwheel loads on left and right to be Before wheel alignment values are adjusted corrected. At the correct height the wheel-load at front and rear axles, it is recommended differenceslie within a permiSS~1 Ie range, or necessary* that the height adjustmentbe provided that the coil springs h ve the same checked at the DIN empty weight. The height installationposition (installedsp ing preload) adjustment possibility allows the wheel-load on each axle. Tolerance:f: 1 m . difference from right to left to be kept as small Wheel-loaddifferences can be kept as low as possible, provided that wheel load weighing as possible in conjunctionwith wheel-load machines are available.The wheel-load weighing machines.Tolerancefrom right to difference is adjusted by changing the vehicle left on front and rear axle unde~15 kg. height within the height tolerance. The priority is to achieve the smallest possible wheel~oad 2. Any impermissible height differences -front difference from left to right. axle to rear axle -can be balanped out (only within the permissibletolerance). Preliminary work I For the height check of the read~-to-drive vehicle (full tank and tools), place the vehicle on a level surface or on the measuring platform. Front axle I Measurefrom wheel contact to the SUrfa;e lower edge of the hexagon-headb It of the tension-strutscrew connectionto e body (Figure74_99). Measuringpoint as for 911 Carrer~ (996). Requiredvaluesfor front and rear laxle in Repair Group 44. * after work which causes a change in height or in the event of an incorrect height 44 -16d 44 Suspension alignment -GT3 9964416a Printed in Germany -34, 1999