A = Clutch pedal area · No. Designation Qty. Removal Installation

911 Carrera (996) Brakes -Brake mechanics A = Clutch pedal area Note: No. Designation Qty. Removal Installation 1 Switch 1 Releaseby turning 90°, and Before installation,pull pull out of the installation operatingplungerout of the opening switch as far as it will go 2 Retainingclip Replace if necessary 3 Pin 4 Clamp Replace 5 Boostspring 1 Secure boost spring with Install the assembly with bracket cotter pin (arrow at No.5) consisting of bracket, Insertthe cotter pin (.£33 mm) boost spring and clutch into the assemblybore and pedal lever, bend over ends. Ensure correct allocation Then undo the three when replacing the boost spring,* * fasteningnuts of the bracket (arrows)and remove the Observe assemblyand boost spring together with adjustmentspecification bracket and clutch pedal for the bracket (assembly lever (No.6) instructionsunder Installation,step 4) 5a Boostspring 2 Replace if necessary, bearing It is important to note instructions regarding grease** 5b Pin It is importantto note instructionsregarding grease** 6 Clutch pedal lever 1 Removetogether with boost spring No.5 and bracket 6X Bushings 2 Remainin the clutch Check, replace if pedal lever necessary. Lubricate. Use specified grease* * Lubricate the bushings of the clutch and brake pedals (6X and 14X)with "Optimol, Optitemp LG 2" grease, Part No.: 000.043.203.37 (deliveryquantity: 80 g tube). * *Please refer to Repair Group 30 -Service No. 30 Clutch boost spring: allocation and grease specification. To see when lubrication of the boost spring bearing points is not permitted, please also refer to the assemblyinstructionsfor installation,steps 3.1 and 3.2. 46 05 19 Removing and installing brake pedal 46 -311111