4. Installationand adjustmentspecificationfor · boost spring bracket.

911 Carrera (996) Brakes -Brake mechanics 4. Installationand adjustmentspecificationfor boost spring bracket. Install preassembled boost spring bracket ~,.~ with clutch pedal lever. To do this: <"~ " Step1: \ ~ Tighten the three fastening nuts (arrows) only 1.+ 5. slightly (the bracket must still be movable). Step2: Tighten the clutch master cylinder to 10 Nm (7.5 ftlb.) (if the clutch master cylinder was detached). Step3: 3~98 Press the clutch pedal againstthe direction of Note travel until the pull stop in the clutch master cylinder is reached. The push rod of the clutch save cylinder should Step 4: not be lubricated in general (for all versions). Removecotter pin (retaining pin) on the spring cup so that the clutch pedal is pressed against 5. Fit new retainer on the pedal bearing axle and the rubber stop in the boost spring bracket. subsequentlysecure the retainer by wedging it with a mandrel. Step5: The bracket is screwed down with the clutch 6. Install clutch pedal switch. pedal pressed back (to make full use of the slots). First pull operating plunger out of the switch Tighten hexagon nuts (arrows) in the prescribed as far as it will go. sequence. Tighteningtorque: 7.5 Nm (5.5 ftlb.). By means of its self-adjustmentfunction, Sequence: Sa / Sb / Sc the switch then compensatesfor tolerances in the pedals. 4.2. 46 -37