Disassembly and assembly instructions · Disassembly Preliminary work and not~s on as

911 Carrera 4 (996) Front wheel suspension, drive shafts Disassembly and assembly instructions Disassembly Preliminary work and not~s on assembly -Tension the coil spring with the spring clamp -Replace nut for fastenin the piston rod on until the piston rod is relieved. the spring strut mount. To undo the connection (piston rod to spring It is recommendedto r~place the coil strut mount) counter at the piston rod with springs only in pairs. I special tool 9630 or a 7 mm Allen key. Important: Never use an impact bolter Note to loosen or tighten the fastening nut. If the coil springs are excharged, it might be necessaryto use a different spring plate than Removeall parts from the piston rod. before. Note The following spring plates ( ompensationparts) When installing new parts, observe the allocation are available: according to the Spare Parts Catalogue. Allocation of the spring plat according to the coil spring tolerance group ( ode B on the coil Disassembleback-up ring no. 4 and mount spring / Fig. 352_99). no. 4A only in the case of replacement. Lever out the mount with a small screwdriver. 1 green line = 6.5 mmlthick compen~ationpart. 1 white line == 3.0 mmlthick compen~ation part. 4 342_99 676_1_96 40 Disassembling and assembling front spring strut -Carrera 4 40 -113 Printed in Germany -28, 1999 C4_40109