Test Work instruction Result Possible causes of fault · open circuit in signal circuit ...2

Test Work instruction Result Possible causes of fault open circuit in signal circuit ...2 kOhm No: -Greater than 2 kOhm: Open circuitI .Measure resistance betweenthe between: following terminals: PSMcontrol modulewiring harness plug PSM control module wiring harness (wiring harness side) terminals8, 10 plug (wiring harness side) terminal 8 and and plug connection X 1/4 terminals 14, 15 PSM control module wiring harness and plug (wiring harness side) terminal 10 front left speed sensor terminals 5, 4 -Less than 1 kOhm: Short circuit in wiring harnessbetween: PSMcontrol modulewiring harnessplug (wiring harness side) terminal 8 and PSMcontrol modulewiring harnessplug (wiring harness side) terminal 10 Note: Disconnectthe plug connection X 1/4 (terminals 14, 15) for further troubleshooting.The connection points 141 and 142 are located in the wiring harness.Check the wiring harnessfor Yes: 104 Qj!!fb1!!~or chafin~~ge. T04 Test: component Less than NO: 0.1 V -PSM control module faulty .Set the measuringrange to alternatingvoltage on the multimeter. .Vehicle jacked up and front left wheel turned slowly by hand .Measure voltage betweenthe following terminals: PSM control module wiring harness plug (wiring harness side)terminal 8 and PSM control module wiring harness plug(~iIi!lglJE!ness side} terminal 10 IVes:TOS 45 -D 118IIITest:1103