fullymatted.
Back to search
996 Carrera Group 0 Part 1 Diagnosis / PAGE 189

PSM diagnosis 911 Carrera 4 (996) · 8.9 Rear right wheel-speedsensor circuit

Add to repair workspace
Open repair workspace
Open full manual Original source
Original manual page 189
Read extracted page text

OCR can contain errors. Check the original page image for exact wording, warnings and specifications.

PSM diagnosis 911 Carrera 4 (996) 8.9 Rear right wheel-speedsensor circuit Test Work instruction Result Possible causes of fault TOI Test: voltage short in signal circuit Less than No: 0.3 V -Short circuit to voltage in the circuit .Ignition off between: .Pull wiring harness plug off of: PSM control module wiring harness plug PSM control module (wiring harness side) terminals 11, 12 .Ignition on and .Measure voltage between the rear right speed sensor following terminals: terminals 5, 4 PSM control module wiring harness plug terminal 11 Note: Disconnect plug connection and X 1/4 (terminals 18, 19) and plug ground connection X 2/4 (terminals 18, 19) for further troubleshooting. Check the wiring harness for pinching or Yes:102 chafing damage. TO2 Test: short to ground in signal Greater No: circuit than 500 -Short circuit to ground in the circuit kOhm between: -Ignition off PSM control module wiring harness plug -Measure resistance betweenthe!following (wiring harness side) terminals 11, 12 terminals: and PSM control module wiring harness rear right speed sensor plug (wiring harnessside) terminal 11 terminals 5, 4 and ground Note: Disconnect plug connection X 1/4 (terminals 18, 19) and plug connection X 2/4 (terminals 18, 19) for furthertroubleshooting. Check the wiring Yes: TO3 harness for pinching or chafing damage. 45 -D 126 II

This is a source reference. Confirm exact model applicability in the original material.