8.3 CAN bus communication circuit · Test Work instruction Result Possible causes of fault

8.3 CAN bus communication circuit Test Work instruction Result Possible causes of fault T01 Test: voltage short in signal circuit Less than No: 11 V -Short circuit to voltage between: Ignition off PSM control module wiring harness plug Pull wiring harnessplug off of: (wiring harness side) terminals 24, 40 PSM control module and and PSM steering-angle sensor wiring PSM steering-anglesensor harness plug and (wiring harness side) terminals 2, 1 DME control module and Ignition on DME control module wiring harness plug Measurevoltage betweenthe IV following terminals: (wiring harness side) terminals 36, 37 PSM control module wiring harness Iplug (wiring harness side) terminals 24, Note: The connection points 135, 136 40 are located betweenthe PSM control and module and the DME control module. round Yes: TO2 These must also be checked. TO2 Test: short to ground in signal Greater No: circuit than 500 -Short circuit to ground between: kOhm PSM control module wiring harness plug Ignition off (wiring harness side) terminals 24, 40 Measure resistance between the and -- Tollowingterminals: PSM steering-anglesensor wiring PSM control module wiring harness harness plug:(wiring plug harness side) terminals 2, 1 iwiring harness side) terminals 24, 40 and and DMEcontrol module wiring harness plug ground IV (wiring harness side) terminals36, 37 Note: The connection points 135, 136 are located betweenthe PSM control module and the DME control module. IYes:103 These must also be checked. 45 -D 236