Fault, Fault code Possible causes, elimination, , notes · Voltmeter at alarm system control module plug I pi

911 Carrera (996) Alarm system diagnosis Fault, Fault code Possible causes, elimination, , notes Voltmeter at alarm system control module plug I pin 32 and ground Voltmeter display: a V Ohmmeter at alarm system control module plug I pin 32 and ground Ohmmeterdisplay: 00.Q Ohmmeter at alarm system control module plug I pin 32 and plug on driver/passenger side door lock pin 3 Ohmmeterdisplay: < 5 .0. If no faults are detected in the wire, replace the door lock. Test point 46 Signalfrom airbagdetected This fault is stored in the memory if the airbag control module transmits Fault code 48 a signal to the alarm system control module after the airbag has been triggered. This is a triggering log. 1. Clear fault memory. Switch ignition off and then on again. Check whether the fault appears again. If the fault reappears,pull off plug II on alarm system control module. Ohmmeteron alarm system control module plug II pin 1 and ground Ohmmeterdisplay: < 5 .Q Check the entire system for operation. Test point 47 K-lead This fault is stored in the memory if the K-leadhas a short to ground Fault code 49 for at least 2 s when the ignition is switched on. Connectspecial tools 9616 and 9617 and switch on ignition. Connectohmmeterto special tool 9616, pin 2 and to ground to check for open circuit. 90 -D 51