Reading out and transferring remote control · General Procedure:

Reading out and transferring remote control General Procedure: When replacing the alarm system control 1. Connect PST2 to the data link connector I and module, it is possible to read out remote switch on the ignition. controls from the old control module and 2. Switch on the PST2, select vehicle type 911transfer them to the new control module. In this (996) and start the automatic control moduleway, the hand-held transmitters (remote controls search with the double arrow key [»].and transponders) can be retained. In other words, it is not necessary to change the 3. After a brief search, the PST2 reports: "Faulthand-held transmitter when replacing the alarm memory reading completed",system control module. 4. Select Alarm system in the menu and press Requirement: the double arrow key [»].-Communication can be set up betweenthe PST2 and alarm system control module. 5. Select Learning functions from the selection list and press the double arrow key [»]. The remote controls and transponder coils are correct and functional. 6. Select menu item Read out remote control and press the double arrow key [»]. Note: When the remote control is read out and 7. The following message appears on the transferred, only the remote control data are screen: read out and transferred. "Input key learning code". The transponder coil of the individual keys must Input the key learning code with the arrow be adapted to the control module. Four keys [v] or [1\] and press the double arrow positions are available for this purpose in menu key [»]. item Transponder key. This function is described from step 19 onward. 8. The following message appears on the screen: 'Please confirm input", Work preparation: Check the input key learning code and press The following information is required from the the key [F7], IPASfor reading out and transferring remote 9. The following message appears on the screen: controls: "Remotecontrols were read ouf'. Press the double arrow key [«] twice to change to the Key learning code control module overview. Switch the ignition Immobilizer code off, remove the old control module, install the new control module and switch the ignition on again.