Fault, fault code Possible causes, elimination, notes · Test point 13

Fault, fault code Possible causes, elimination, notes Test point 13 Signal, terminal 86 5 PCM Note Open circuit This fault is stored only if the ignition is switched on Fault code 32 for at least 1 minute. 1. Checkfuse E 1 2. Pull off plug II on the display and operator control unit. 3. Connect voltmeter to plug II pin 3 (positive) and ground. Switch on ignition. Display: Battery voltage. Note The lead is routed via jumper plug 13/1 on relay carrier 1 Test point 14 Navigation, CD fault Replacenavigationunit. CM faulty/navigation unit Value range Fault code 33 Test point 15 Navigationfault, gyro Replacenavigationunit. CM faulty/navigation unit Value range Fault code 34 9101 Diagnosis/troubleshooting, PCM