A = Clutch pedal area · No. Designation Qty. Removal Installation

911 Carrera (996) Clutch, actuation A = Clutch pedal area Note: No. Designation Qty. Removal Installation 1 Switch 1 Releaseby turning 90°, and Before installation,pull pull out of the installation operating plunger out of opening the switch as far as it will go 2 Retainingclip 1 Replace if necessary 3 Pin 1 4 Clamp 1 Replace 5 Boost spring 1 Secure boost spring with Install the assembly with bracket cotter pin (arrow at No.5) consisting of bracket, Insertthe cotter pin (/33 mm) boost spring and clutch into the assemblybore and pedal lever. bend over ends. Ensure correct allocation Then undo the three fasten- when replacing the boost spring. * * ing nuts of the bracket (arrows)and remove the Observe assemblyand boost spring together with adjustmentspecification bracket and clutch pedal for the bracket (assembly lever (No.6) instructionsunder Installation,step 3) 5a Boost spring bearing 2 Replace if necessary. It is important to note instructionsregarding grease** 5b Pin 1 It is important to note instructions regarding grease** 6 Clutch pedal lever 1 Removetogether with boost spring No.5 and bracket 6X Bushings 2 Remainin the clutch Check,replaceif necessary. pedal lever Lubricate. Use specified grease* Lubricate the bushings of the clutch and brake pedals (6X and 14X) with "Optimal, Optitemp LG 2" grease, Part No.: 000.043.203.37 (deliveryquantity: 80 g tube). * * Information can be found in Repair Group 30 -Servo No. 30 Clutch boost spring: allocation and grease specification. To see when lubrication of the boost spring bearing points is not permitted, please also refer to the assemblyinstructionsfor installation,steps 2.1 and 2.2. 30 05 19 Removing and installing the clutch pedal 30 -11 Printed in Germany -18, 1998 996309