4. Grease specification 4.2 Clutch master cylinder push rod · Do not grease, as this could result in dama

911 Carrera (996) Clutch, actuation 4. Grease specification 4.2 Clutch master cylinder push rod Do not grease, as this could result in damage. The following grease specification must be observed during assemblywork on the pedals. 4.3 Area around boost spring Dependingupon the type of boost spring used,4.1 Pedal bearing axle greasing is either necessaryor not permitted. Greasing generallynecessary. The followinggeneralrule applies:Do not grease Lubricate sliding surfaces of the bearing coated parts, as otherwise the coating is lost. bushings X and the pedal bearing axle with Optimal, Optitemp LG 2, 4.3.1 Carrera Mod. '98/ some Mod. '99 Part No. 000.043.203.37. A. Boost springs installed as standard: Push rod open on one side. Parts uncoated. Grease pin for boost spring (arrow) with mating bearing on the boost spring push rod, the boost spring bearing (arrows)and the bearing pins on the boost spring with Optimal,Optitemp LG 2, Part No. 000.043.203.37. First remove old grease with solvent naphtha. The boost spring and interior of the boost spring housing are lubricated with a special grease. This grease is not available as a spare part. If necessary,replace the complete boost spring (with housing). A -Clutch pedal lever 466_98 B -Brake pedal ~C -Steering outer tube X -Bearing bushings 1 -Retainer 31_1_98 30 Clutch boost spring: allocation and grease specification 30 -19 Printed in Germany. 18, 1998 9963017