Removingand installing transmission · 1. Removeunderbodypanels(middleand rear). 7. Unscrewthe clutch slave cylinder and ha

Removingand installing transmission Removal 1. Removeunderbodypanels(middleand rear). 7. Unscrewthe clutch slave cylinder and hang up at the side with the hose connected. 2. Removethe cross member which passes under the transmission. Note The clutch pedal must not be pressed if the 3. Secure the engine in installation position with slave cylinder has been removed. special tool 9624/1. To do this, remove the Danger of injury from flying piston rod. mountingfor the stabilizer, swivel the Affix a warning note in the vehicle! stabilizer forward and screw on special tool 9624/1 with four fastening screws. 8. Disengage shift and selector cables on the Screw in the pressure screw until the transmission: pressure disc has contact with the crankcase, (o/f - IJ' "-'" -;;/-:::;~ ..,,~ 133-97 132-97 Note 4. Removedrive shafts at the transmission and The shift and selector cables must not be protect the shafts against damage (use scrap excessivelybent or kinked. pieces of hose with a diameter of 30 mm). Pull off shift and selector cables at the 5. Disconnectthe plug connection for the transmission shift and selector levers. reversing light switch. 6. Unclip the hydraulic line for the clutch slave cylinder at the side transmission case cover. 34 -4 34 35 19 Removing and installing transmission G 96 996341 Printed in Germany, 1997