Additional instructions for adjusting the door window · The power windows can be operated if: Fitting the door

Additional instructions for adjusting the door window The power windows can be operated if: Fitting the door window in the clamping jaws -the ignition is switched on. 2 after the ignition is switched off I if the ignition key is not removed from the steering lock. 3, after the ignition is switched off until a door is opened for the first time. 4. with a door open. 451_97 Standardising the system Installing the door window in t.. doorThe system must be re-standardisedafter an interruption in the power supply to the power Insert the door windowthrough th~ door channel window electronics in the door. into the clamping jaws of the front and rear The position values for the short-stroke lowering drivers. The bottom edge of the window must function, position-controlledlowering function rest on the screw during adjustment. Position in the case of convertible top actuation and the door window corner flush with the driver enablingfor "automatic start-up of window at front. Tighten the clamping jaws after closing" (one-touchfunction) are redefined. completing the adjustment. The standardisationprocess is initiated by Tightening torque: 8.5 1.5 Nm continuous actuation of the operating button (6.5 1.0 ftlb.) toward "close window". The button must be held until the window is closed and is switched off by the blockage detection function of the power windows. Blockage detection function If the window drive encountersresistance during the door windowmovement, the motor is switched off after a delay of 500 ms. 57 -18 57 51 37 Disassembling and assembling door (adjustment instructions) 9965717 Printed in Germany -21, 1999