60 14 15 Re-teaching the lifting/sliding roof drive · It is necessary to re-teach the lifting/sliding 4. If the li

911 Carrera (996) Sliding roof 60 14 15 Re-teaching the lifting/sliding roof drive Note It is necessary to re-teach the lifting/sliding 4. If the lifting/sliding roof drive should move roof in the event of emergencyoperation or back in Item I, then the closing force replacement of parts on the lifting/sliding roof limitation function has responded (seals, sliding-roof drive) or if the entire system (lifting/sliding force drive was taught). is replaced. The "open" button must be re-taught The data of limit positions and characteristics in this case. are stored and are retained even if the battery is disconnected. Teaching 1. Press the "open" button until the sliding roof Teaching stops. Then release the button. Press again 1. With the ignition switched on, press the "lift" until the lifting/sliding roof drive stops again. button and move the lifting/sliding roof drive Then release the button. to the "raised" limit position. 2. Press "open" button again and keep 2. Press " Iift" button again and keep depressed, depressed. The entire process takes After around 10 seconds, a complete cycle place after approx. 10 seconds: takes place from the "raised" limit position "close -lift -lower -open -close". to the positions "Iower -open -close". 3. Teachingof the characteristicshas been completedafter this process. Note The "raise" button must not be released during the entire process. In the event of a restart, the lifting/sliding roof must always be moved to the raised limit position first. 60 14 15 Re-teaching the lifting/sliding roof drive 60 -11 Printed in Germany -17, 1998 996609