fullymatted.
Back to search
996 Carrera Group 6 Body Equipment, Exterior / PAGE 56

A Caution! · Damage to hydraulic system if hydraulic lines are trapped or crushed during installation

Add to repair workspace
Open repair workspace
Open full manual Original source
Original manual page 56
Read extracted page text

OCR can contain errors. Check the original page image for exact wording, warnings and specifications.

911 Carrera (996) Convertible top, hardtop A Caution! Damage to hydraulic system if hydraulic lines are trapped or crushed during installation .Pay special attention when routing 1:he hydraulic lines in the clips. Installinghydrauliccylinder Position hydrauliccylinder with the drive levers on the con- vertible-topsupport, and insert potentiometer fork in the pin of the hydraulichousing(on the left side only). 7 Laying lines to hydrauliccylinder Lay hydraulicline -Figure A- in the clips underneaththe water drain hose. Presshydraulic lines into the clips in -Figure B- and -Figure C-. Tighten M8 hexagonnuts. Tighteningtorque 17:t 2 Nm (12.5:t 1.5 ftlb.). Secure drive lever with the retaining clip SBL 10. => Removaltool; Rep.Gr. 2.4, Nr. 131; Workshop Equip- ment Manual 8 Installingspray protection Insertthe spray protection in the chamber in the water col- lection tray. 9 Engagingtension cables Fold down tension bow and press ball socket of the left and right tension cables into the ball head of the adjusting element. 10 Installingside-panellining Insert side-panellining into the guide rail at rear, position on the belt guide section at front, and fasten with the B 4.2 oval-headscrews. Insert collar for the windstop until it engages. Tighten holding pegs with Allen key St6. Positioncross. recess screw on the sheetmetal bracket in the cut-outfor the loudspeaker,andtighten. Plug in electrical plug connection of loudspeakers.Position loudspeakersand secure with the Torx screws. 11 Convertibletop calibration Connectthe Porsche System Tester 2 to the diagnostic socket. Switch on the ignition. Select menu item .Convertibletop., and select menuitem .Calibrate.in the command line which then appears. Start the calibrationwith the -F7 key-. Calibrationcan be started irrespective of whether the con- vertible top is open or closed. The latching hook in roof frame 1 does not close during calibration. 610119 Removing and installing convertible top 61-1 page 13 Printed in Germany -41,2000 c6101191

This is a source reference. Confirm exact model applicability in the original material.