Adjusting convertible top Check dimension on convertible top after · calibration of the assembl

911 Carrera (996) Convertible top, hardtop Adjusting convertible top Check dimension on convertible top after calibration of the assembly aids The assembly aids must be recalibrated after removal or after an accident repair in the area of the side section on the inside. The calibration of the assembly aids represents the basic position for convertible top installation. The required tools include a tape measure and a rule or an aluminiumsection at least 1600 mm long, which is laid over the rear side sections, front centre, first Roof Transport System fastening hole. Dimension A = 135 mm is measured from the rear side parts to the assembly aid, centre of peg on the rear side section on the inside. DimensionB = 118 mm is measuredfrom the upper fastening point, centre of hole 113_98 for convertible-topsupport (rear side part on inside),to the assemblyaid. After calibration of the assembly aids and fitting of the convertible top with convertible top Dimension C = 1064 mm is measured from closed, the check dimensionfrom the styling centre of assembly aid peg to lower edge of edge, roof frame 1, lower edge diagonalto convertible-top peg housing on inside. styling edge, roof frame 3, upper edge, rear should be E = 1024 +/- 2 mm. Adjusting convertible-top peg housing In order to avoid rattling noises, each of the convertible-toppeg housingson the left and right must be facing outwards in relation to the centring pins fitted on the convertible top or hardtop when tightening. Note: The convertible top must be closed and the hardtop must be fitted to check the adjustment. 61 01 15 Adjusting convertible top 61 -43 Printed in Germany -28, 1999 9966123