fullymatted.
Back to search
996 Carrera Group 6 Body Equipment, Exterior / PAGE 108

61 70 19 Removing and in!ttalling convertible-top compartment lid drive · Move the convertible top to service position

Add to repair workspace
Open repair workspace
Open full manual Original source
Original manual page 108
Read extracted page text

OCR can contain errors. Check the original page image for exact wording, warnings and specifications.

911 Carrera (996) Convertible top, hardtop 61 70 19 Removing and in!ttalling convertible-top compartment lid drive Removal Move the convertible top to service position 5. Pullmotorforwardsout of the toothing. prior to removal. Installation 1. Move convertible top rearward by means 1. Set the potentiometerto 6.2 ko. before of the electric motor until the convertible-top installingthe motor. compartment lid has reached the rear end position. 2. Connecta commerciallyavailabledigital Move convertible top forward by means multimeter to pin 3 (blue/yellow)and pin 5 of the electric motor until the convertible-top (redjblack). compartment lid moves forward. Then interrupt closing operation. 3. Removethe potentiometerfrom the motor and turn on the toothing until it reaches 2. Disengage left and right tension cables a value of 6.2 kn . and fold up the tension bow. The convertible top must no longer be electrically operated in this position. 4. Install potentiometer and motor. Tighteningtorque for: 3. Removethe cover over the drive. Pull off Hexagonthread bolts M5 6 Nm (4.5 ftlb.] the plastic funnel and undo the two M6 Hexagonnuts M6 10 Nm (7.5 ftlb.) hexagon nuts. Disconnectthe electrical plug connection of the control module. 5. Once the motor has been installed, the potentiometer must be recalibrated with the Porsche System Tester 2. ~ 6. The values betweenpot. 2, calibrationvalue \, I, and pot. 2, calibration value 4, are /1(' calculated in percent by the convertible-top ) control module. Pot. 2, CTCL 0 -Pot. 2 calibration value 1 Tester display must be greater than> 1.0 volts / -Pot. 2 calibration value 2 -Pot. 2 calibration value 3 201_98 -Pot. 2 calibration value 4 Tester display must be smaller than < 3.9 volts 4. Pull the motor backwards out of the bracket and loosen and remove the hexagon thread bolts. 61 70 19 Removing and installing convertible-top compartment lid drive 61 -67 Printed in Germany -11, 1998 9966167 ~

This is a source reference. Confirm exact model applicability in the original material.