Removing rear power windows (Cabriolet) · No. Procedure Instructions

911 Carrera (996) Glazing, window control Removing rear power windows (Cabriolet) No. Procedure Instructions Convertible top in service position See procedure: ServoNo. 61 01 19 Note: Removaland installation of the rear power window should be carried out with a rear window pane. Otherwise adjustmentwork is hindered during installation. 1 Removeside-panellining See procedure: ServoNo. 70 75 19 2 Removerear side window Undo front and rear M6 x 20 hexagon nuts from inner seal the convertible-topsupport and the belt guide section, and pull rear side window inner seal up and out. 3 Closeside window Press the micro-switchin the windscreenframe and actuate the rocker switch at the same time. 4 Releasepowerwindow Releaseadjusting elements with the adjustmenttool. To do this, loosen and unscrewthe M8 nuts from the adjusting element. Adjustmenttool for the rear power window. Refer to Workshop EquipmentManual,Chapter2.4, No. 123-1 Warning: Damage to or destruction of the convertible top when the convertible-top support is removed!& > The convertible top must no longer be electricallyoperated when the convertible-top support is detached. 5 Detach convertible-top Undo M8 x 40 hexagon-headbolts and M8 hexagon nuts support from the convertible-topsupport, pull the deflection fitting and belt guide section up and out. Pull convertible-topsupport inward and fix between B-pillar and the convertible-topsupport with a spacing block dimension A = 30 mm. 6 Removepower window Push rear power window upward, push both locking tabs of the electrical connection outward and disconnect. 64 71 19 Removing and installing rear power windows (Cabriolet) 64 -41 Printed in Germany -17, 1998 9966439