Installing rear power windows (Cabriolet) · No. Procedure Instructions

911 Carrera (996) Glazing, window control Installing rear power windows (Cabriolet) No. Procedure Instructions Insert power window Connectelectrical plug connections, insert power window into the window shaft from above and position in the mounts in the inner side section. 2 Screwdownconvertible-top Removespacing block between B-pillarand convertible-top support support. Position and fasten M8 x 40 hexagon-headbolts and M8 hexagonnuts in the convertible-topsupport. Tightening torque 23 Nm (17 ftlb.) Insert deflection fitting into the belt guide section. Insert and screw in M8 x 20 hexagon-headbolt. Tightening torque 50 Nm (37 ftlb.) 3,4 Adjustand screwdown By movingthe power windowwith respectto the longitudinal powerwindow axis of the vehicle,the power window can be adjusted by dimension Y= :!: 10 mm. The contact pressure of the side window upper edge on the convertible-topis adjusted by screwing the adjusting element in or out by dimensionX = :!: 10 mm. The contact pressure on the rear window inner seal or the offset from the door window is adjusted by screwing both of the upper adjusting elements B in or out by dimension X =:!: 5 mm. Adjustmenttool for the rear power window, see Workshop EquipmentManual,Chapter 2.4 No. 123-1 Step 1: (Figure 3) Adjust the basic setting of the adjusting elementsB from the top edge of the rear side section to the side window. DimensionC Fronttop edge of rear side section = 11 mm DimensionD Reartop edge of rear side section = 14 mm Step 2: (Figure 3) Push the power window backward or forward to adjust the gap betweenthe side window and door window to E = 9 mm. Step 3: (Figure4) Adjust the contour or the offset from the door window on adjusting elementA. Screw down adjusting elements A, B. Tightening torque 23 Nm (17 ftlb.) 64 71 19 Removing and installing rear power windows (Cabriolet) 64 -43 Printed in Germany -17, 1998 9966439