Installing sill cover -GT3 · No. Procedure Instructions

911 Carrera (996) Exterior equipment Installing sill cover -GT3 No. Procedure Instructions Removeadhesiveremainsfrom Removeadhesiveremains from the sill cover with a rotary the sill cover brush and clean with Betaclean3350. Detach the retaining strip and remove the adhesiveremains. 2 Only after repair or retrofitting Clean side member panel and side section up as far as the of the side member stone shield with Betaclean9950 and primer with panel Betaprime 5402. Clean and primer side Observe drying time for Betaclean9950 (1 minute) member panel and side Drying time for Betaprime 5402 (2 minutes). section 3 Only after repair or Open vehicle doors and remove protective film from the retrofitting of the side adhesive points of template set 9655. The template set is member panel marked on the left and right accordingly. 'Hi' for rear I 'Mi' Position the template set for middle and 'Vo' for front. (use special tool 9655) Dimensions: A = 50 mm B = 268 mm C = 570 mm D = 440 mm Note: The positioning of the templates and the retaining strip (height)are determined by the body contour and the shape of the respectivetemplate. It is not permissibleto drill holes in the vehicle side member (risk of corrosion)! 4 Fasten retaining strip Secure retaining strip with a second person Screw in the self-tappingcountersunksheetmetalscrews 3.5 x 16. Note: Whenfitting new holes with self-tappingcountersunk sheetmetal screws, use a drill to support the new sheetmetal screws to be screwed in. !:; Adjustsill cover Insert rear end of sill cover into the rear wheel housing and engage into the retaining strip. The sill cover must cover the standard fitted stone shield and should be seated (dimension E) approx. 5 mm below the vehicle side member. If necessary,drive the sill cover carefullyinto the retaining strip with a plastic wedge. 66 31 19 Removing and installing sill cover -GT3 66 -15 Printed in Germany -25, 1999 9966611