Installing sill cover -GT3 · No. Procedure Instructions

911 Carrera (996) Exterior equipment Installing sill cover -GT3 No. Procedure Instructions 6 Clip in U-clips Clip in U-clipson the vehicle undersideon the rim of the side member panel. The tab of the U-clips must point toward the outside of the vehicle. 7 Glueon adhesivefilm Stick the adhesivefilm onto the fastening point at the front of the sill cover near the wheel housing. Puncturethe fastening hole which is covered with film using an awl. 8 Applyadhesive Apply adhesiveflush into the groove of the retaining strip along its entire length. Apply a 40 mm long and dimension X = 10 mm high adhesivebead to the corner points of the side member panel in the direction of the arrow. 9 Fit sill cover With the help of a second person, insert the side member panel into the rear wheel housing and into the groove of the retainingstrip. The sill cover must cover the standard fitted stone shield and should be seated 5 mm below the upper edge of the vehicle side member. If necessaryI drive the sill cover carefully into the retaining strip with a plastic wedge. Tighten both ends of the sill cover with the sheetmetal screws 4.8 x 13. 66 31 19 Removing and installing sill cover -GT3 66 -17 Printed in Germany -25, 1999 9966611