No. Procedure Instructions · 10 Positionassemblyaids Stick suitable adhesivetape, e.

911 Carrera (996) Exterior equipment No. Procedure Instructions 10 Positionassemblyaids Stick suitable adhesivetape, e.g. white Tesa tape Use specialtool no. 9655/1 4651, loosely onto the door and the sill cover. Insert the assembly aids vertically from above the adhesive tapes into the door gap. Tilt the assemblyaids outward horizontally,thereby putting pressure on the adhesive tapes. 11 Position wooden spacer blocks Stick suitable adhesive tape, e.g. white Tesa tape 4651, ShoPfnade wooden spacer loosely onto the door and the sill cover. Insert the wooden blocks 9 ea. 70 x 90 x 12 spacer blocks vertically from above between the adhesive tapes and the sill cover with the rubber base towards the paint side. Tilt the wooden spacer blocks outward horizontally,thereby putting pressure on the adhesive tapes. 12 Screw sill cover onto vehicle floor Tighten the sheetmetal screws 4.8 x 13 on the fastening points of the sill cover on the vehiclefloor. Note: When screwing in the lower sheetmetal screws, the sill cover must be pressed outwards to reduce the gap dimensionwith respect to the vehicle side member. The following materials are required for assembly work on a sill cover: Designation Qty. Size Supplier Wooden spacer block 9 ea. Wood-coreplywood 12 mm thick, 70 x 90 mm Commerciallyavailable Base 9 ea. Rubber base 2 mm thick, 40 x 100 mm Commerciallyavailable Note: The bonded joint does not have its final strength immediately.In order to ensure that the bonded joint is sufficientlystrong, the following boundary conditions must be adhered to: Curing time 2 hours Temperature at least +100 C to +350 C Working time of adhesive 17 minutes Car wash operation not until 48 hours later The vehicle must not be used until the curing time has elapsed. 66 31 19 Removing and installing sill cover -GT3 66 -19 Printed in Germanv -25. 1999 9966611