Removing roll-over protection system · ~ Important:

911 Carrera (996) Passengerprotection Removing roll-over protection system ~ Important: ill Danger of injury during assemblywork! The roll-over bar module can be triggered. > Removethe roll-over bar modules only after the roll-overbar has been extended (triggered), No. Procedure Instructions 1 Removingrear wall lining Removeoval-headscrews from the rear wall lining on the left and right, and detach the auxiliaryframe. Removerear wall lining. 2 Removingcover Unclip the cover over the roll-over protection system at the rear, unscrewthe T20 x 35 Torx screws at the front, and lift the cover up and off. 3 Triggering roll-over protection Note: system with the Porsche Actuate the roll-overprotection system only if: System Tester 2 the hardtop is removed the convertible top is open the caps are removed, Connectthe Porsche System Tester 2 to the diagnostic socket, Switch ignition on, Select menu item "Roll-overprotection", Select menu item "Drive links" in the command line which then appears, Press the key combinationdescribed in the Tester; the roll-overprotection system is triggered, 4 Undoinghexagonsocket Undo the M8 x 30 hexagon socket head bolts from the head bolts modules in the auxiliaryframe and pull out in downward direction. 5 Disconnectingelectrical Press the electrical plug connection (arrow A) and plug connection pull apart. 69 72 19 Removing and installing roll-over bar 69 -25 Printed in Germany -21, 1999 996692.1