Removing and installing frame for roll-over protection system · No. Designation Qty. Removal

911 Carrera (996) Passenger protection Removing and installing frame for roll-over protection system Note: No. Designation Qty. Removal Installation Hexagon-headbolt 4 Undo Tightening torque: MID x 25 65 :t 6 Nm (48 :t 4.5 ftlb.) 2 Collar nut MID 4 Undo Tightening torque: 48 Nm (36 ftlb.) 3 Frame Undo hexagon-headbolts Positionframe in the (Item 1) and collar nuts vehicle. Dimension A: (Item 2), and lift frame 491 ::t 1 mm ( (Item 3) out of the vehicle Figure C). Measure centre of screwed point (convertible-topsupport), side section on inside,to frame cutout on right and left. Tighten hexagon- head bolts (Item 1) and collar nuts (Item 2) 4 Collarnut M6 2 5 Relaybox 1 6 Wiring harness 7 Oval-headscrew 84.2 x 12 10 8 Convertible-top 1 control module 9 Hexagon-headbolt M6 x 16 4 Tightening torque: 9.7 Nm (7.0 ftlb.) 10 Holder 2 11 Hexagon-headbolt M6 x 20 4 Tightening torque: 9.7 Nm (7.0 ftlb.) 12 Right bracket 13 Left bracket 1 14 Clip 2 Inspect and replace if necessary 69 77 19 Removing and installing frame for roll-over protection system 69 -31 Printed in Germany -7, 1998 9966929