69 74 19 Removing and installing control module for roll-over protection system · Removeignitionkey.

911 Carrera (996) Passengerprotection 69 74 19 Removing and installing control module for roll-over protection system Removal Removeignitionkey. 2. Disconnectthe battery and cover terminal or battery. 3. Slightly loosen centre console and push forwards a little (refer to ServoNo. 68 17 19). 4. Removethe two rear belt buckles and take out the seat wells. 5. Undo the trim of the seat wells from the carpeting and lift up in the middle. 200_98 6. Using a support tool, support the trim and unscrew and remove the plastic screw (Torx T30) from the control module cover. Installation 1. Install the roll-over protection control module in the centring holes with the fixing pins, ~. -,""" and secure with shear-offnuts. ~~ 2. Use a 1/4 inch Allen key to tighten 7~ "'/ ~~ the shear-offnuts. (. !II ,. 3. wireEngagecarefully.electricalInstallplugcontrolconnectionmoduleandcover,route seat wells, belt buckles and centre console. (.J 4. Followingthe installation of a new control ~ module for the roll-overprotection system, the transport lock must be deactivatedwith 211_98 the Porsche System Tester 2 (refer to Group 0, Entire vehicle -General, Sales check, 7. Disconnectthe electrical plug connection. Page 01 -1). Undo the shear-offnuts using special tool 9259, and remove the roll-over protection control module. 69 74 19 Removing and installing control module for roll-over protection system 69 -33 Printed in Germany -11, 1998 9966933