Installing roll-over bar -GT3 · No. Procedure Instructions

Installing roll-over bar -GT3 No. Procedure Instructions 1 Fit right spring dome support Positionthe spring dome support section in the rear of the section passenger compartmentonto the spring strut mount on the right. Tighten with the fastening nuts MI a (fastening nuts must alwaysbe replaced).Tightening torque 46 Nm (34 ftlb.). Carry out a test drive after performing assemblywork on the roll-overbar/spring support on the body and then retighten the MIa fastening nuts (three per side)to the same torque. 2 Fit left spring dome support Positionthe spring dome support section in the rear of the section passenger compartmentonto the spring strut mount on the left. Tightenwith the fastening nuts MID (fastening nut must alwaysbe replaced).Tightening torque 46 Nm (34 ftlb.) 3 Fit selector sleevesand base cage Push selector sleevesonto the spring dome support sec- tions on the left and right. Positionthe base cage onto the sections of the spring dome support. Push the selector sleeves upwardsover the connector tube of the base cage. Turn the selector sleevesonto the hole pattern of the base cage and of the spring dome support sections. Fit the hexagon socket head screws M8 x 55 and tighten with the fastening nuts M8. Tightening torque 16 Nm (12 ftlb.) 4 Fit left side of base cage onto Positionbase cage onto the screwed points. Positionthe underbody counterplateon the vehicle underbodyon the outside and fasten with the M8 x 25 hexagon-headbolts, 8.4 washers and the M8 fastening nuts. Tightening torque: 23 Nm (17 ftlb.) 5 Fit right side of base cage onto Positionbase cage onto the screwed points. Positionthe underbody counterplateon the vehicle underbodyon the outside and fasten with the M8 x 25 hexagon-headbolts, 8.4 washers and the M8 fasteningnuts. Tightening torque: 23 Nm (17 ftlb.) 69 72 19 Removing and installing roll-over bar -GT3 69 -41 Printed in Germany -29, 1999 9966935