Removing selector sleeves -9- Unscrewfastening nuts -5- from the fastening screws -8-, · Pushthe selector sleeves -9- o

911 Carrera (996) Passenger protection Removing selector sleeves -9- Unscrewfastening nuts -5- from the fastening screws -8-, Pushthe selector sleeves -9- on to the spring dome sup- port sections -C, D-, 7 Removingbase cage -C- on right side of Unscrewthe fastening nuts -5- and the washer -6- from underbody the base cage -C -, 8 Removingbase cage -C- on left side of Unscrewthe fastening nuts -5- and the washer -6- from underbody the base cage -C -, Guidethe base cage -C- out of the passenger compart- ment. rn Note! In order to unscrew the fasteningnuts -7- from the spring strut mount, the vehicle must be standing on its wheels. Detaching right spring dome support sec- Unscrewthe fastening nuts -7- and guide the spring dome tion -D- support section -D- out of the right spring strut mount. a)Carry out a test drive after performing assemblywork on the roll-overbar/spring strut mount threaded parts on the body and then re-tightenthe fastening nuts (three per side) to the torque: 46 Nm (34 ftlb.). The fastening nut -7- must alwaysbe replaced. 10 Detaching left spring dome support section Unscrewthe fastening nuts -7- and guide the spring dome -E- support section -E- out of the left spring strut mount. a)Carry out a test drive after performing assemblywork on the roll-overbar/spring strut mount threaded parts on the body and then re-tightenthe fastening nuts (three per side) to the torque: 46 Nm (34 ftlb.). The fastening nut -7- must alwaysbe replaced. a) Only when commissioning the vehicle without a roll-over bar 697219 Removing and installing roll-over bar -GT 3 -as of model year """ 69-45 page 5 Printed in Germany -42,2000 c6972193