Mountthe side-panellining Insert pegs of the side-panellining -1- on the inside of the · rear side section and o

911 Carrera (996) Linings,insulation Mountthe side-panellining Insert pegs of the side-panellining -1- on the inside of the rear side section and on the frame of the roll-over protec- tion. Press clip -8- into the inside rear side section. Clip must engageaudibly. Positionfastening screw -12- into the sheetmetal bracket in the cut-outfor the loudspeaker,and tighten. Plug in elec- trical plug connection -II-of loudspeakers.Positionthe loudspeakerin the side-panel-1- and fasten with the fas- tening screws -9-. ? Fitting holding pegs and cover Positionthe cover trim -3- and the holding peg -2- in the cut-out of the side-panellining and screw in tightening torque 20 Nm (15.0 ftlb.) 3 Fit cover Press in collar -7-, collar must engage audibly. Checkthe clips -5- or replace. Fastenthe side-panellining with the fastening screw -6-. Press the locking tabs of the cover -4-into the clips -5-. 4 Fit seal Lift up the pillar seal along the side-panellining using a plastic spatula-arrow-. 707519 Removing and installing side-panel lining -cabriolet 70-45 page 5 Printed in Germany-44. 2001 c7075192