Installing GT3 bucket seat · No. Procedure Instructions

911 Carrera (996) Seat frames Installing GT3 bucket seat No. Procedure Instructions Fit seat screws at rear and front Position seat rails on the seat baseframe, screw the rear MID x 28 Torx screws into the seat baseframe on the left and right using the E 12 socket wrench insert. Move seat to its rear limit position, screw the front MID x 28 Torx screws into the seat baseframe on the left and right using the E 12 socket wrench insert and tighten. Tightening torque 65 Nm (48 ftlb.) 2 Fit seat rail cover. Push seat rail cover into front end of the left and right seat rails until the seat rail cover engages. Screw in the sheetmetal screw B 3.2. 3 Pull six-point seat belt through Pull six-pointseat belt through the upper opening in the the openings in the seat backrest from behind (arrow A) and through the opening in the seat frame from the side (arrow B). Note: The belt assemblyprocedure also appliesfor the standardbelt. 4 Fit belt fitting Position belt fitting on the seat frame and fasten. Attach covering cap. Use the foam part arrow C for the Club Sport version. Use the bushing arrow D for the Cup racing version. Tightening torque: 50 Nm (37 ftlb.) 5 Loop technique for fastening The belt strap is looped around the transverse strut in the to the bucket seat cross direction of the arrow (inset) and into the adjustableslider. member The projection of the belt strap (dimension X) must be at least 100 mm. 6 Loop technique for fastening to The belt strap is looped around the transverse strut in the the roll cage cross member direction of the arrow (inset) and into the adjustableslider. The projection of the belt strap (dimension X) must be at least 100 mm. Roll up the projecting belt strap and bind it with a tie wrap. 72 01 19 Removing and installing bucket seat -GT3 72 -11 Printed in Germany -25, 1999 996727 1