Technical Information · 18/17 ENU 4075 4

911 (996) Technical Information 18/17 ENU 4075 4 2.1.5 ONLY for the relevant coil spring (see table): Press spring plate (compensation part Figure 4 -1-) into the support ring/deep-groove ball bearing assembly (Figure 4 -2-). 1 – Spring plate (compen- sation part) 2 – Support ring/deep-groove ball bearing assembly 3 – Spring strut supporting mount Figure 4 2.1.6 Complete support ring/deep-groove ball bearing/spring plate (compensation part) assembly with spring strut supporting mount. 2.1.7 Fit spring strut supporting mount assembly on the piston rod. Make sure that the end of the coil spring is inside the spring plate (underside of spring strut supporting mount). 1 – Spring strut/supporting mount assembly 2 – End of coil spring 2.1.8 Position stop plate at the correct position above the spring strut supporting mount and fit new lock nut (M14 x 1.5) on the thread of the shock absorber piston rod. Tightening torque 80 Nm (59 ftlb.) Figure 5 3 Concluding work 3.1 Install front spring strut ( Workshop Manual '408519 Removing and installing front spring strut') 3.2 Fit wheels on the front axle and lower the vehicle. 3.3 Check wheel alignment values on the front axle and make adjustments if necessary. 40 85 20 00: ONLY for 911 Carrera (996)/911 Targa (996)/911 Millennium (996): AfterSales AprPage17,5 2018of 6