PSM 05 911 Turbo (996)45 · pump motor and checking their feedback. It only makes sense to

PSM 05 911 Turbo (996)45 pump motor and checking their feedback. It only makes sense to carry out the "Static test" function if no fault has previously been detected as present, i.e. the system has not switched off. Note! This test must be carried out after the hydraulic unit has been exchanged. Swap test The swap test is used to check the allocation of the brake pressure lines to the wheel brake cylinders. A hydraulic and an electrical test are carried out. Note! This test must be carried out after the hydraulic unit has been exchanged. Bleeding The brake system can be bled using this menu item. ⇒Rep. Gr. 470107; Bleeding brakes Steering-angle sensor calibration The steering-angle sensor can be calibrated with this menu item. The steering-angle sensor must be calibrated after work has been carried out on the running gear in the area of the front axle. The security code is required for calibration of the steering-angle sen- sor. The security code is contained under menu item "Actual values".⇒Rep. Gr. 4560; Steering-angle sensor calibration 45-5 page 4 4503 Control module function SGF_ps05 Printed in Germany – 5, 2001