Instrument cluster K20 911 Turbo (996)90 · 6. Observe the instructions of the diagnosis tester, enter the tota

Instrument cluster K20 911 Turbo (996)90 6. Observe the instructions of the diagnosis tester, enter the total mileage with the tabulator key, check and then press the F8 key to code the entered total mileage. The total mileage can also be read out from the old instrument clus- ter under the menu item "Control module replacement" and can be transferred into the new instrument cluster if the old replacement instrument is still functional and if it is possible to establish commu- nication with the PST 2. Tank calibration See on this subject ⇒20; Rep. Gr. 201501 ; Calibrating fuel level sensor system. Speedometer A A speed can be simulated under this menu item to check the func- tion of dynamic volume control (speed-dependent volume). If the function of the dynamic volume is switched on and the speed is sim- ulated by means of PST 2, the volume must change according to the speed. The higher the simulated speed, the higher the volume. Control module replacement Certain values can be read out of the old instrument cluster and can be tranferred into the new instrument cluster. A prerequisite for this is that the communication can be set up between the old instrument cluster and PST 2. The following values can be read out of the old instrument cluster and can be transmitted into the new instrument cluster: ♦Total mileage ♦Tank calibration ♦Vehicle Ident. No. Note! ♦The country coding is not read out and transferred via this func- tion. ♦Correct country coding is a prerequisite of the correct function- ing of the instrument cluster. 90-5 page 4 9025 Control module function Sgf_xk20 Printed in Germany – 11, 2001