Coding country-specific tuner settings · 1. 9588 Connect and start the Porsche System Tester II and

911 Turbo (996) PCM2/CDR23 91 Coding country-specific tuner settings 1. 9588 Connect and start the Porsche System Tester II and switch on the ignition. 2. Select '911 Turbo (996)' in the Vehicle type menu and confirm with the >> key. 3. Select 'PCM2' in the control modules selection and confirm with the >> key 4. Select 'PCM2 GW' in the control modules selection and confirm with the >> key. 5. Select the 'Coding' menu item and press the >> key. 6. Select the menu item 'Tuner parameters' and press the >> key. 7. Take the country-specific code as it appears in the table, enter it in the form and code with the F8 key. MOST switch The MOST switch is part of the PCM2. If external MOST control units are present, they will only work if the MOST switch is open. The following settings can be coded: ♦MOST switch open. ♦MOST switch closed. Note! ♦When the PCM2 is replaced, the coding must be performed in accordance with the vehicle equipment. ♦When the 'Switch closed' parameter is set, the switch remains closed even in existing MOST control modules. Communication is then not possible. Coding PCM2 1. 9588 Connect and start the Porsche System Tester II and switch on the ignition. 2. Select '911 (996)' in the Vehicle type menu and confirm with the >> key. 3. Select 'PCM2' in the control modules selection and confirm with the >> key 4. Select 'PCM2 GW' in the control modules selection and confirm with the >> key. 9101 Gateway - introduction 91-59 page 5 Printed in Germany – 43, 2003 EINGWlwl