PCM2/CDR23 911 Turbo (996)91 · 3. Select 'PCM2' in the control modules selection and confirm

PCM2/CDR23 911 Turbo (996)91 3. Select 'PCM2' in the control modules selection and confirm with the >> key. 4. Select 'PCM2 GW' in the control modules selection and confirm with the >> key. 5. Select 'Coding' in the PCM2 GW function selection and confirm with the >> key. 6. Select 'Production mode' in the PCM2 GW coding and confirm with the >> key. 7. Select 'Production mode off' menu and code with the F8 key. The following options can be coded: ♦Production mode off ♦Production mode on Replacing CDR23 control modules The PCM2 is converted to delivery mode (low-current mode) in pro- duction. As known from other systems (alarm system, instrument cluster, roll-over bar), the PCM2 must be activated with the 9588 Porsche System Tester ll. 1. 9588 Connect and start the Porsche System Tester II and switch on the ignition. 2. Select the menu item 'Special functions' and press the >> key. 3. Select the menu item 'Vehicle hand-over' and press the >> key. 4. Follow the instructions of the 9588 Porsche System Tester II. Control module replacement - PCM2 The PCM2 is supplied in 'production mode on' in new vehicles and as a spare part. Before putting the PCM2 into operation, the 'Pro- duction mode on' must be set to 'Production mode off' in the Cod- ing menu when selecting the function of the PCM2-GW, and the vehicle must be locked and secure. Afterwards, PCM2 is functional. The procedure is explained in detail under 'Production mode'. 91-85 page 4 9101 Introduction – external Harman amplifier EINVSlwl Printed in Germany – 43, 2003