94-13Fault code 7 · Calibration not performed yet

911 Turbo (996) Headlight beam adjustment HBA 01 94 94-13Fault code 7 Calibration not performed yet Diagnostic conditions • Ignition on • Terminal 58 on Possible cause of fault ♦Calibration has not yet been carried out for newly installed con- trol module Affected terminals - Diagnosis/Troubleshooting Work instruction Display OK If not OK 1 Calibrate control module ♦Select menu item Calibration in End Continue with 2 the Porsche System Tester 2 ♦Observe instructions on the screen ♦Carry out calibration Note! Calibration is not possible if the sensor voltage lies outside the plau- sible range (sensor voltage less than 2 V or greater than 3 V). Work instruction Display OK If not OK 2 Check sensor voltages ♦Select menu item Actual Values 2 - 3 V Continue with 3 in the Porsche System Tester 2 End ♦Vehicle on level surface (not raised) 3 Visual inspection ♦Check sensor holder and linkage End Replace sensor for damage holder and linkage End 9492 Fault code 7 94-13 page 1 Printed in Germany, 2001 7xxxlw01