01 Sales check · Fitting roll cage -GT3

01 Sales check Fitting roll cage -GT3 General The screwed roll cage is not fully fitted on vehicle delivery if the vehicle is suppliedwith Club Sport equipment. The front sections (A-pi!larsupport) of the roll cage which are delivered separatelyfrom the vehicle must be fitted on to the base cage. Note: Do not tighten any of the screwed points until the screws have been screwed in. Use cprrect tightening torques! 162_99 Fitting left section 2. Positionthe section (A-pillarsupport) on the screwed points at the front. Positionthe counterplateon the outside of the vehicle underbodyand fasten with the M8 x 25 hexagon-headbolts, 8.4 washers and the M8 fastening nuts. Tightening torque: 23 Nm (17 ftlb.) 160_99 1. Insert the left section of the roll cage (A-pillar support) from the left door and position at the rear on the screwed points of the base cage. Fastenwith the M 8 x 12 hexagon socket head bolts. Tightening torque: 23 Nm (17 ftlb.) 01 Sales check 01-7 Printed in Germany -25, 1999 99601_7