5/9/2014 RoW M030 Sport Suspension Install - Carrera (996) - Mods - 996 (Carrera) - DIY - Tutorials - RennTech.org Foru

5/9/2014 RoW M030 Sport Suspension Install - Carrera (996) - Mods - 996 (Carrera) - DIY - Tutorials - RennTech.org Forums 5. Try turning the bolt as you feed it through so that the threads don’t catch. This was by far the hardest part of the entire install and took 3 guys to line it up and push it through. 6. Once through, install the new strut in the reverse as described above and use the sheet below for torque values: Carrier side section/cross member Location T hread T ightening torque [Nm] (ftlb.) Carrier side section to body M12 x 1.5 110 (81.5) Studs for carrier side section to body (screw-in M12 x 1.5 46 (34) torque only) Cross member at rear to carrier side section M12 x 1.5 110 (81.5) Cross member at front to carrier side section MIa x 1.5 65 (48) Brake hose holder to carrier side section M6 10 (7 .5) Diagonal brace to body MIa x 1.5 65 (48) Diagonal brace to cross member M12 x 1.5 110 (81.5) Diagonal brace to carrier side section (collar nut) M10x1.5 23 (17 ) Axle strut Location T hread T ightening torque [Nm] (ftlb.) Control arm 2 (toe control arm) to wheel carrier M12 x 1.5 7 5 (56) To cross member (toe eccentric) M12 x 1.5 100 (7 4) Lower axle strut to carrier side section (camber eccentric) M12 x 1.5 100 (7 4) To wheel carrier M12 x 1.5 7 5 (56) Camber basic setting on two-part lower axle strut M8 27 (20) - 911 GT3 RS Diagonal arm to cross arm M14 x 1.5 160 (118) To carrier side section M14 x 1.5 180 (133) Control arm 3 and control arm 4 (upper control arms) M12 x 1.5 110 (81.5) To carrier side section M12 x 1.5 110 (81.5) To wheel carrier Wheel carrier Location T hread T ightening torque [Nm] (ftlb.) Wheel bearing to wheel carrier (lid) M8 37 (27 ) Speed sensor to wheel carrier M6 10 (7 .5) T ightening torques for rear axle http://www.renntech.org/forums/tutorials/article/88-row-m030-sport-suspension-install/?forcePrint=1&_k=893ccccbb84b100141dbbbe5e95342e1 10/12