No. Procedure Instructions · 11 Spot-weldlighthousing Spot-weldlight housingwith the c

911 Carrera (996) Body rear 53 No. Procedure Instructions 11 Spot-weldlighthousing Spot-weldlight housingwith the connecting angle and the connectionto the transverse lock pan~l. On the inside of the side section (small figure), make sure that the welding nuts are lined up with the hole pattern in the side section. Screw in M6 hexagol1l-headbolts to position. Spot-weldthe connectionwith the side section. 12 Weld cross member under Weld the overlap of the cross member at the top with a shielding gas stitch weld seam under shielding gas. Weld the overlap on the lower side section connection under shieldinggas. 13 Mark bores for the insertion Cut the water channelas a template out of the removed bushings side section as shown in Figure 13, Pliltit on the spare body part (side section)and mark the bores for the insertion bushings.Bore a 9.0 mm m, rk in the water channelusing a twist drill. 14 File off insertionbushingsand File off both bores to the hexagon of the insertion bushing insert using a needle-pointfile. I Insert the insertion bushing using the blind rivet nut manual device. Blind rivet nut manual device: refer to Workshop Equipment Manual,Chapter2.4, No. 125. 53 55 55 Replacing side section -Cabriolet 53 -31 Printed in Germany -33, 1999 9965323 Downloaded from www.Manualslib.com manuals search engine