Porsche DME 7.8 — OBD II Diagnosis Manual / PAGE 49
DME 7.8 DME 7.8 0 · Specified resistance values are based on an ambient
Read extracted page text
OCR can contain errors. Check the original page image for exact wording, warnings and specifications.
DME 7.8 DME 7.8 0
Note!
Specified resistance values are based on an ambient temperature
of 20°C unless otherwise stated.
End of troubleshooting (→ End)
→ End marks the end of the described diagnosis/troubleshooting in
the troubleshooting tables. The procedure for repair can be taken
from the relevant workshop manual for the particular repair group.
After successful repair, the fault memory of the DME control module
must be cleared and, if necessary, adaptation of the throttle adjust-
ment unit performed, followed by a short test or test drive to
achieve the diagnostic conditions for the particular fault. Afterwards
the fault memory must be read out again. Depending on the coun-
try, Ready statuses must be generated.
2470 INTRODUCTION 0-PEIN page 15
Printed in Germany – 14, 2003 PEIN2DME78
This is a source reference. Confirm exact model applicability in the original material.