DME 7.8 DME 7.8 0 · The new programming code must match the DME programm

DME 7.8 DME 7.8 0 Note! The new programming code must match the DME programming code from the IPAS, otherwise the control module can no longer be programmed later. ♦Enter and confirm 'New immobilizer code'. Note! The new immobilizer code must match the immobilizer code from the IPAS, otherwise the control module can no longer be pro- grammed later. ♦Select data record. Note! ♦If the data record OBD II was selected in the old control module, the tester automatically preselects "Data record OBDII". ♦The selection must then simply be confirmed. Programming commences after this confirmation. ♦When programming is complete, switch off the ignition. ♦Switch on the ignition. ♦Switch off the tester. Note! In Tiptronic vehicles, the fault memory of the Tiptronic must be erased following the programming of a DME control module, as the fault "CAN timeout" is entered in the memory during programming. 3. Program map/data The data record can be changed, e.g. from RoW to OBD II, with this menu item. Only the DME programming code is required. 4. Program immobilizer code The immobilizer code is transferred to a new DME control module with this menu item. Data Output with the Porsche System Tester 2 0-2a page 13 Printed in Germany – 4, 2002 pst_dm78